C1319 Jensen Jensen-healey Engine Fault Code

Check Solution For C1319 Jensen Jensen-healey OBD Code :

C1319 Jensen Jensen-healey engine code seems a kind of chassis problem, we try to show one by one the meaning and the solution.
Brief explanation of the C1319 Jensen Jensen-healey code and definition of C1319 Jensen Jensen-healey is the bottom side.

C1319 Jensen Jensen-healey Meaning :

c Chassis Code
Problem is controller area network wiring bus and modules.
1 MFG - Manufacturer Specific
3 IC Module 4X Ref Circuit Intermittent, No Pulses
1 Low Coolant Circuit
9 Kick-Down Switch Failed Short

MFG - Manufacturer Specific codes, which have a '1' as their second digit to indicate they are unique to a particular vehicle make or model. These special codes were deemed necessary by the vehicle manufacturers so they could provide additional diagnostic information beyond the basic list of generic OBD II codes for all kinds of faults, not just emissions-related faults.

How To Fix C1319 Jensen Jensen-healey ?

The oxygen (02) sensors on your car measure the oxygen in the exhaust to determine how rich or lean the ratio of fuel and air are in the cylinders. Optimizing this mixture means better fuel economy and fewer exhaust emissions.

C1319 Jensen Jensen-healey Code Description:

While fuel economy was increased, acceleration was seriously compromised, and the loss of engine vacuum led to a dangerous loss of braking assist when the C1319 code system was in four-cylinder mode. In addition to these issues, while the company proposed a hydraulically controlled system that could be switched from within the car, the version they implemented had to be manually changed in the engine compartment using hand tools. When you see C1319 Jensen Jensen-healey engine fault code on your engine code reader this description will help you.

C Codes List of all Chassis codes.

Final Step: In the definitions listed below, there is a test drive recommended after you've completed any repairs to see if the condition is fixed. Before you take a test drive after a repair, always erase the C Code(s) first. This will turn the check engine light off and then you will know if the check engine light returns, you've got further diagnostics to complete.

BE CAREFUL !
This engine code information is presented for information purposes only. This is not intended as repair advice and we are not responsible for any actions you take on any vehicle.

About Us | Contact | Privacy

Copyright © 2016 - EngineFaultCode.com
All rights reserved.
Sitemap

Valid CSS!